CarAudioForum.com

Go Back   CarAudioForum.com > UseNet Gateway > F.A.Q. > Subwoofers

Reply
Old 07-14-2002, 07:46 PM   #1
Lee

Administrator
 
Join Date: May 1997
Location: Pensacola, FL
Posts: 22,799
Lee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond reputeLee has a reputation beyond repute



How can I carpet my enclosure?

Quote:
4.11 How can I carpet my enclosure? [AO]
What you will need:
  • Carpet.
  • Adhesive (3M Super 77 or Super 90 is excellent.)
  • A good sharp pair of scissors.
  • A razor sharp utility knife. Buy a BOX of blades, they go dull fast.
  • Solvent to clean up excess adhesive.

Before you start, find a large, clean, flat surface on which to set the box as you carpet it. Start by unrolling the carpet onto the surface, smoothing it out so that its flat, and setting the box on top of it edgewise. Also, make sure that you remove the speaker, any ports and terminal cups from the box.

The instructions on how to carpet the box are as follows: [list=1][*]Place the box such that it is centered on the carpet lengthwise, and one edge of the box is about one inch from the edge of the carpet. [*]Roll the box back so that the side of the box that was previously done faces forward, and the carpet beneath it is exposed. Coat both the box and carpet with adhesive, but do NOT apply the carpet to the box - the adhesive needs a few minutes to set up (follow the instructions from your adhesive to find out how long you should wait). [*]After the adhesive has set up, roll the box back into position. Wait a few more minutes for the adhesive to bond. [*]Now coat the side of the box adjacent to the remaining carpet (the side facing backwards) and the carpet next to it with adhesive, let the adhesive set up, and roll the side you just coated onto the coated carpet. Repeat this until three sides of the box are carpeted. [*]Before carpeting the next side, the 1 inch of carpet sticking over the edge must be removed. To do this, rotate the box so that the first side that was carpeted is up. Pull the carpet sticking over the edge down towards the uncarpeted edge and cut it off with the knife, flush with the uncarpeted side of the box. You will have to run the knife nearly parallel to the uncarpeted side to get a perfect cut. [*]This done, spray the remaining side and carpet, and roll the box onto it. Shear off the remaining carpet sticking out from all edges with the scissors leaving a 1 inch border everywhere. [*]Clean up the ends of the box so that the carpet is flush with the sides of the box as in step 4. [*]Next cut off the remaining 1 inch flap of carpet (located at the point where you began carpeting). This is the tricky part, as you don't want to be able to see this seam. Again, pull the flap down over the edge of the box, but this time cut it at roughly a 45 degree angle. If you are successful you shouldn't be able to see the wood under the seam, but will probably see the white of the adhesive and the back of the carpet. [*]Soak some of the solvent onto a rag and use this to scrub the edge you just cut off. It should dissolve the adhesive and the carpet backing somewhat, causing the carpet on the edge to become fuzzy. Keep scrubbing the edge until you can no longer see the seam. [*]Now carpet the ends of the box. Cut two pieces of carpet slightly larger than the ends of the box and lay one of them flat on the surface. Spray the carpet and one end of the box with adhesive, and set the end of the box on the carpet, so the box stands on end. [*]After the adhesive has dried sufficiently cut off the remaining border of the carpet as in 7 and 8. [*]Repeat step 9 and 10 for the other end of the box. [/list=1]

Congratulations! You've just carpeted your box!
Lee is offline   Reply With Quote

Sponsored Links
Help Syrian Refugees Survive. Donate Now!
Or text REFUGEES to 50555 to give $10 to USA for UNHCR
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Forum Jump


All times are GMT. The time now is 12:37 AM.
Powered by vBulletin® - Copyright © 2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 1996 - 2011 by CarAudioForum.com - all rights reserved.