|11-30-2015, 03:34 PM||#1|
Join Date: Nov 2015
Becker Replacemant with Pure Highway Radio
Bought a Pure Highway H260DBi Dab radio, to replace Land Rover Becker unit that is not working. Checked the fittings from web page and looked a lot closer that many other units that had only one block on the back of them.
See Pure Wiring Diagram and Becker Wiring Diagram.
Dark when I got home but couldn’t wait till weekend so tried the connections and plugged in and great it worked but mainly from the front Left Speaker. Messed about with the controls of the radio but the balance and fader were not that obvious so gave up.
Tried again in the light and using the balance fader controls get some tinny sound from other speakers but not a lot more.
I assumed that as the speaker connections from block B on both radios are the same that this would go via the sound system and work as it should.
Again assumed that the Audio Jacks on the Pure unit would be for a separate amplifier and if you do not have one you do not connect them!Is that correct?
Block A connections are not exactly the same and is it there is no power going to my amplifier.
Is block C relevant now as I am not too concerned about the Steering wheel buttons, disk changer etc.
Comparing Block A connections
A1 Pure = NC (no connection!) Becker Unit -Speed Dependant Volume Control
A2 Pure Telemute - BeckerUnit - *
A3 Pure -NC BeckerUnit – Muting for telephone
A4 Pure – Battery BeckerUnit – Battery
A5 Pure – AMP Remote BeckerUnit - Control output for Antenna
A6 Pure -NC Becker Unit –Illumination
A7 Pure –ACC+ BeckerUnit - Switched plus
A6 Pure -Ground BeckerUnit – Ground
Basically can anyone advise on how I can get this head unit to work with the existing Becker Sat Nav System with Harman/Kardon soundsystem
What are the pins A5 AMP Remote and A7 ACC+ on the Pure
Lots of Questions appreciate any response